FOGATTI InstaHeat Ultra 35K vs Suburban SF-FQ RV Furnaces

A research-based comparison of FOGATTI's InstaHeat Ultra 35K and Suburban's SF-FQ RV furnaces, using official specs, cabinet and service-access details, published FOGATTI prices, and warranty terms as of November 17, 2026. No hands-on testing.

FOGATTI InstaHeat Ultra 35K vs Suburban SF-FQ RV Furnaces

Disclosure: This page may contain affiliate links. They do not influence our editorial conclusions. Read the disclosure.

Our pick

  1. Top pick

    FOGATTI

    FOGATTI is an RV comfort brand that sells InstaHeat propane furnaces, InstaShower water heaters, InstaCool rooftop air conditioners and RV kitchen appliances on...

    See price at FOGATTI

Jump to the full guide

FOGATTI and Suburban both make ducted, 12-volt gas RV furnaces aimed at mid-size and large coaches, and FOGATTI itself treats Suburban's SF-FQ family as a primary replacement-orientation reference. On the official RV furnace collection page, FOGATTI lists a matching-BTU InstaHeat furnace as the intended counterpart to a Suburban SF-xxFQ unit when the existing furnace uses a front gas inlet — then immediately tells shoppers to confirm the complete model number, BTU rating and installation requirements rather than assume a drop-in fit.

This comparison looks at that pairing as it stood on official pages on November 17, 2026: FOGATTI's InstaHeat Ultra 35K on fogatti.com, and Suburban's SF-FQ series on suburbanrv.com, including the 35,000 BTU/h SF-35VHFQ in Suburban's 2025 aftermarket catalog. It is a research-based reading of those documents, not hands-on testing, and not a claim that either furnace will fit a specific coach without measurements.

FOGATTI InstaHeat Ultra 35K RV furnace, official product photo of the black cabinet, blower and duct collars

What each brand actually sells

The InstaHeat Ultra 35K is a single ducted LP-propane furnace with a maximum output of 35,000 BTU and four selectable heating levels: 17,000, 25,000, 30,000 and 35,000 BTU. Official specifications also list Rapid, Standard and Sleep operating modes, 320 CFM airflow, a 40 dB sleep-mode sound rating, a 0.10 in. WC duct static-pressure figure, 12V DC power at a rated input of 120W / 10A, seven 4-inch round duct openings, and a cabinet of 17.7 W × 7.8 H × 20.1 D in, weighing 27.6 lbs (12.5 kg). Horizontal and vertical mounting are both supported when the approved bracket and manual clearances are used. The wired controller is included.

Suburban's SF-FQ series is a family of low-profile ducted furnaces with direct spark ignition and sealed, forced-draft combustion. The official SF-FQ series page describes the design as built for interior serviceability: a front (inside) gas connection, only a small vent terminal on the coach exterior, installation up to 9 inches from the wall, and no exterior access door. Suburban's 2025 aftermarket catalog lists the current models as SF-20VHFQ (20,000 BTU/h), SF-25VHFQ (25,000), SF-30VHFQ (30,000), SF-35VHFQ (35,000) and SF-42VHFQ (40,000). The 35,000 BTU/h counterpart to the InstaHeat 35K is therefore the SF-35VHFQ (catalog part 2587A), not a four-level version of one cabinet.

The official SF-FQ product page, when loaded on November 17, 2026, displayed the SF-20FQ (part 2551A) with these published specifications: dimensions 7.5" × 17" × 20", weight 29 lbs, 12-volt supply, 5.1 amp draw, two 4-inch ducts, 55 square inches of required return air, and a 2-year limited warranty. Those amp, duct and weight figures belong to the 20,000 BTU model shown on that page. Suburban does not publish a matching airflow (CFM), sleep-mode, or multi-level output figure on the SF-FQ pages reviewed for this article, so those items are not compared as if they were official Suburban specifications.

Suburban SF-FQ series RV furnace, official product photo of the metal cabinet with side duct openings and a louvered end

Heat output and comfort features

The sharpest official difference is how output is organized. The InstaHeat 35K keeps one cabinet and lets the user step between 17K, 25K, 30K and 35K BTU, with Rapid, Standard and Sleep modes and a stated 40 dB sleep setting. FOGATTI's product page frames that as a way to recover quickly, then run at a lower overnight level. The RV furnace collection table also describes the 35K's control as a smart wired controller with ±1°F adjustment and diagnostic alerts.

Suburban's approach is a ladder of separate models. For 35,000 BTU/h, the catalog points to the SF-35VHFQ. If you need more, Suburban still lists a 40,000 BTU/h SF-42VHFQ, which is above anything in FOGATTI's current InstaHeat lineup (20K, 25K, 30K and Ultra 35K). Lower outputs are sold as separate SF-FQ models, just as FOGATTI sells separate InstaHeat sizes; how to choose among those heat levels is a different decision from this comparison.

Airflow is documented on the FOGATTI side — 320 CFM and 0.10 in. WC — and is not listed on Suburban's SF-FQ product pages. A missing official number is not evidence that the Suburban furnace moves less air; it only means that part of the comparison has to come from the installation manual for the exact model in the coach.

Cabinet, ducts and the "will it fit" test

FOGATTI's 35K page repeats the same fit checks it uses across the lineup: match calculated heat load, not the badge; confirm cabinet, duct, return-air and exhaust fit; and verify propane supply, 12V power and clearances. The stated cabinet is 17.7 × 7.8 × 20.1 in, with seven 4-inch duct openings. The company says the furnace "fits compatible 35K furnace cabinets and central duct systems," which is a compatibility claim, not a guarantee for every Suburban opening.

The numbers are close to, but not identical with, the SF-20FQ cabinet published on Suburban's product page (7.5" × 17" × 20") and the 20 × 17 × 7.5 in. dimensions listed for Suburban's 2610A furnace-core replacement module, which the core page associates with SF-35FQ / SF-42FQ applications. A few tenths of an inch can decide whether a replacement slides in and whether a door or vent cap lines up. FOGATTI's collection page asks buyers to confirm the existing furnace's complete model number, BTU rating, front gas-inlet configuration and installation requirements, and to contact support if compatibility is unclear.

Duct counts should be checked the same way. The InstaHeat 35K is specified with seven 4-inch openings. The SF-FQ product page lists two 4-inch ducts and 55 square inches of return for the SF-20FQ — a 20,000 BTU specification that should not be assumed for an SF-35VHFQ. Compare the actual duct map, return air, exhaust and gas-inlet side with FOGATTI's installation manual before ordering.

FOGATTI also sells the 35K as a furnace core only, currently $594.99 for the Front core on fogatti.com. Suburban sells slide-in cores as well, including the 2610A module for SF-35FQ / SF-42FQ cabinets, with a two-year limited warranty. A core swap only makes sense when the existing cabinet, ducts and exhaust stay in place and the new core is the one specified for that cabinet.

Doors, gas connections and service access

This is where the SF-FQ design is most clearly documented. Suburban says SF-FQ models are serviced from inside, use a front (inside) gas connection, need only a small exterior vent terminal, can be installed up to 9 inches from the wall, and do not require an exterior access door. That is a different layout from Suburban's SF-Q series, which the company says uses top or side rear gas and electrical connections and an exterior access door.

FOGATTI's 35K is sold in several official configurations: No Door or a Black or White Door, Front or Back intake, plus the Front core-only option. On November 17, 2026, the in-stock configurations on fogatti.com were No Door / Front at $639.99 (the page also showed a $1,299.99 compare-at price), Black Door / Front and White Door / Front at $739.99, and Furnace Core Only / Front at $594.99. Back-intake versions were listed but marked out of stock. Door and intake choices have to match the coach's exterior access and gas routing; they are not cosmetic afterthoughts.

Both companies expect a qualified technician to install or service a gas furnace. Suburban's product pages say its gas appliances are to be installed or serviced by a qualified service technician. FOGATTI's warranty policy requires a qualified professional and excludes installation, removal, on-site labor and transportation from coverage.

Controls, what is included, and how you buy

The InstaHeat 35K includes a smart wired controller and product documentation. FOGATTI also notes that ducting, propane-line materials and vertical-mount brackets may need to be ordered separately. Suburban's 2025 catalog states that thermostats and doors are sold separately, so a quote should be checked for those items before it is compared with a complete FOGATTI configuration.

Purchase path is different too. FOGATTI publishes consumer prices and ships direct from fogatti.com; the No Door / Front 35K was in stock on November 17, 2026, with a stated window of 3–5 business days. Suburban does not list a retail price on the SF-FQ product pages. It sells through RV retailers, dealers and service centers, and an honest comparison cannot invent a Suburban street price from a third-party listing.

Warranty, as written

FOGATTI's warranty policy, current on November 17, 2026, gives RV furnaces a 12-month limited warranty from the date of purchase. The 35K product page describes a 1-year warranty on a direct order, with the order serving as proof of purchase and no separate registration form required. The policy is limited to defective hardware and FOGATTI-supplied replacement components. Labor, removal, installation and shipping are excluded, and repairs must use genuine FOGATTI parts.

Suburban's official warranty page says registration is not required; a bill of sale is enough to establish the warranty period, and the owner's manual has the full terms. The company's North American warranty manual (part 205642, dated May 11, 2026) states that furnaces have a two-year limited warranty on parts and labor to the original owner, and that furnace heat exchangers have continued coverage during the third through fifth years without a labor allowance. The same 2-year limited warranty is printed on the SF-FQ product page and in the 2025 catalog. Suburban also offers an optional paid extension for the heat exchanger, which is a separate purchase with its own conditions — not part of the standard limited warranty.

That is a meaningful official difference: Suburban publishes longer furnace coverage, including later heat-exchanger years, while FOGATTI's furnace term is 12 months and does not include labor. Warranty language is not a performance test, and it does not override a poor fit.

How to use this comparison

Choose the InstaHeat Ultra 35K if the official four-level output, 320 CFM rating, Sleep mode and included wired controller match how you want the furnace to run, the cabinet and front-gas layout actually fit, and you prefer a direct fogatti.com order with a published price. Read the InstaHeat Ultra 35K review for the full specification and configuration list, and the November 2026 thermostat-upgrade news for the most recent official product update.

Stay with a Suburban SF-FQ, or budget for a same-brand replacement, if you need the 40,000 BTU/h SF-42VHFQ, want to keep a Suburban cabinet and use a factory core, or prefer the two-year parts-and-labor term and later heat-exchanger coverage through Suburban's dealer and service network.

In either case, start with the furnace that is already in the coach: complete model number, BTU rating, gas-inlet location, cabinet measurements, duct and return-air layout, exhaust, propane supply and 12V capacity. FOGATTI's own replacement notes also mention Furrion FFG xx FA front-gas-inlet furnaces as another orientation reference; those are a different comparison and are not specified here. For shipping, returns and how a fogatti.com order is warranted, use the FOGATTI shopping guide. Prices, stock and official specifications change, so re-check the product pages before you buy.

References

Meet your guide

Lipeiguan

author